- Hydrogenation and Electrochemical Characteristics of Amorphous-nanostructured Mg-based Alloys
-
A. Gebert, B. Khorkounov, L. Schultz
-
J Korean Powder Metall Inst. 2006;13(5):327-335.
-
DOI: https://doi.org/10.4150/KPMI.2006.13.5.327
-
-
 Abstract
 PDF
- In the development of new hydrogen absorbing materials for a next generation of metal hydride electrodes for rechargeable batteries, metastable Mg-Ni-based compounds find currently special attention. Amor phous-nanocrystalline Mg_63Ni_30Y_7 and Mg_50Ni_30Y_20 alloys were produced by mechanical alloying and melt-spinning and characterized by means of XRD, TEM and DSC. On basis of mechanically alloyed Mg-Ni-Y powders, complex hydride electrodes were fabricated and their electrochemical behaviour in 6M KOH (pH=14,8) was investigated. The electrodes made from Mg_63Ni_30Y_7 powders, which were prepared under use of a SPEX shaker mill, with a major fraction of nanocrystalline phase reveal a higher electrochemical activity far hydrogen reduction and a higher maximum discharge capacity (247 mAh/g) than the electrodes from alloy powder with predominantly amorphous microstructure (216 mAh/g) obtained when using a Retsch planetary ball mill at low temperatures. Those discharge capacities are higher that those fur nanocrystalline Mg_2Ni electrodes. However, the cyclic stability of those alloy powder electrodes was low. Therefore, fundamental stability studies were performed on Mg_63Ni_30Y_7 and Mg_50Ni_30Y_20 ribbon samples in the as-quenched state and after cathodic hydrogen charging by means of anodic and cathodic polarisation measurements. Gradual oxidation and dissolution of nickel governs the anodic behaviour before a passive state is attained. A stabilizing effect of higher fractions of yttrium in the alloy on the passivation was detected. During the cathodic hydrogen charging process the alloys exhibit a change in the surface state chemistry, i.e. an enrichment of nickel-species, causing preferential oxidation and dissolution during subsequent anodization. The effect of chemical pre-treatments in 1% HF and in 10;mg/l;YCl_3/1%;H_2O_2 solution on the surface degradation processes was investigated. A HF treatment can improve their anodic passivation behavior by inhibiting a preferential nickel oxidation-dissolution at low polarisation, whereas a YCl_3/H_2O_2 treatment has the opposite effect. Both pre-treatment methods lead to an enhancement of cathodically induced surface degradation processes.
|
kpmi
